Design Features

1. Successfully tested for compliance with Australian Standard AS 2047.

2. Optional meeting stile strengths cover a large variety of design wind load areas.

3. Fixed mullion nests into the horizontal frame sections - tight joint with no ugly rivets through the front face.

4. Fixed lights can be reglazed from inside the building - no expensive scaffolding or dangerous ladders required on elevated installations.

5. Standard cam handle or alternative key type available, located on the jamb for maximum security.

6. Ventilation type key lock available.

7. Opening sashes run on large diameter wheels ensuring smooth operation.

8. 50mm wide perimeter frame will couple to a large variety of adaptor - no screws or rivets required.

9. Besides the obvious standard windows this system can be fabricated as four light sliders, sliders over or under adjustable glass louvres and fixed lights out of slider frame.

10. Fixed sill has built-in drainage to take care of condensation.

11. Sashes will accept up to 6.38mm laminated glass with full wrap around glazing channel.

12. Fixed glass hard up against the outer face, no ledges to catch dust and beaded on the inside.

13. Flyscreens tuck into the head and sill, held by nylon clips - screens removed from inside.

14. It is possible to re-hand the sliding window after installation - change type 'SF' to 'FS'.